Discontinued IF5317 (Discontinued) 500C Large Vacuum Oven with Vacuum Pump & Water Chiller DZF-6090-HT

Power Supply

• Single phase 208~240 VAC 50/60 Hz.
• 2600 W with a 20A breaker required

Construction

• The chamber is constructed from stainless steel, welded with support pieces.
• Two racks with SS304 heating plates inside the vacuum chamber for direct heating. Note: Never place samples directly on the heating plate; use a ceramic plate or a stainless-steel tray to hold the samples.
• Chamber material: Stainless steel 1Cr18Ni9Ti
• Chamber size: 18 x 18 x 18", (460 x 460 x 460 mm, 91 litres, 3.4 Cubic Feet)

Temperature Control

• Two programmable temperature controllers are equipped for discrete control of each heating element
• 30 segments programmable with ± 1℃ accuracy
• Continuous operating temperature: 50 - 500 ℃
• Max. operating temperature: 550℃ for < 2 hours
• The maximum temperature difference between the two zones: 100℃.
• Temperature uniformity: ±5℃ in 12x12x12" chamber mid-zone.
• The software and PC interface module are available at an additional charge.

Vacuum Pump & Pressure Gauge

• Two-stage vacuum pump with an exhaust filter installed at the bottom.
• Maximum vacuum: <133pa or 2 Torr
• Built-in mechanical vacuum gauge
• A gas flow meter with 1000 mL/min for monitoring gas display, filling, and flow.
• A rotary vane vacuum pump with exhaust filter, bellows, and KF-D25 inlet is included

Water Cooling

• A digitally controlled water circulation chiller EQ-KJ5000 is included.
• Cooling range: 5~35℃
• Flow rate: 16L/Minute
• Capacity of coolant tank: 6 litres
• Use a corrosion-resistant coolant for optimal performance.

Warranty

• One-year limited warranty and lifetime support

Certification

• CE certification
• NRTL or CSA certification available upon request and at an additional charge.

Product Dimensions

• 610 x 690 x 1350 mm (24" x 27" x 53")

Shipping Weight and Dimensions

• 610 lbs.
• 48 "x40 "x65"

Application Notes

• For precise temperature measurement, calibration can be conducted using the temperature calibration kit.
• For further details on calibrating the oven temperature, please refer to the documentation.

Caution

• After heating the oven to high temperatures, the chamber may become dull and discolour. These are normal phenomena that do not affect the oven's performance. All samples inside the chamber should not come into contact with the chamber wall.